3Com WXR100 3CRWXR10095A - Manual (Page 116)

116 C HAPTER 3: S YSTEM S ERVICE C OMMANDS
set system name Changes the name of the WX switch from the default system name and
also provides content for the CLI prompt, if you do not specify a prompt.
Syntax — set system name string
„ string — Alphanumeric string up to 256 characters long, with no
blank spaces. Use a unique name for each WX switch.
Defaults — By default, the system name and command prompt have the
same value. The factory default for both is the model number (WX1200
for the 3Com Wireless LAN Switch WX1200, WX4400 for the 3Com
Wireless LAN Controller WX4400).
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — Entering set system name with no string resets the system
name to the factory default.
To view the system name string, type the display system command.
Examples — The following example sets the system name to a name
that identifies the WX switch:
WX4400# set system name WX-bldg3
success: change accepted.
WX-bldg3#
See Also
„
clear system on page 92
„
display system on page 95
„
set prompt on page 107
„
set system contact on page 108
„
set system location on page 115