3Com WXR100 3CRWXR10095A - Manual (Page 220)

220 C HAPTER 7: IP S ERVICES C OMMANDS
See Also
„
clear interface on page 185
„
display dhcp-client on page 196
„
display interface on page 200
set interface
dhcp-server Configures the MSS DHCP server.
Use of the MSS DHCP server to allocate client addresses is intended for
temporary, demonstration deployments and not for production networks.
It is recommended that you do not use the MSS DHCP server to allocate
client addresses in a production network.
Syntax — set interface vlan-id ip dhcp-server [enable |
disable ][start ip-addr1 stop ip-addr2][dns-domain
domain-name][primary-dns ip-addr [secondary-dns ip-addr]]
[default-router ip-addr]
„ vlan-id — VLAN name or number.
„ enable — Enables the DHCP server.
„ disable — Disables the DHCP server.
„ start ip-addr1
— Specifies the beginning address of the address
range (also called the address pool).
„ stop ip-addr2 — Specifies the ending address of the address range.
„ dns-domain domain-name
— Name of the DHCP client’s default DNS
domain.
„ primary-dns ip-addr
[secondary-dns ip-addr] — IP addresses of the DHCP client’s DNS
servers.
„ default-router ip-addr
— IP address of the DHCP client’s default
router.
Defaults — The DHCP server is enabled by default on a new
(unconfigured) WXR100, in order to provide an IP address to the host
connected to the WX for access to the Web Quick Start. On all switch
models, the DHCP server is enabled and cannot be disabled for directly
connected MAPs.
The DHCP server is disabled by default for any other use.