3Com WXR100 3CRWXR10095A - Manual (Page 248)

248 C HAPTER 7: IP S ERVICES C OMMANDS
„ notify-only —The switch can use the string to send notifications.
„ read-write
—An SNMP management application using the string
can get and set object values on the switch.
„ notify-read-write — An SNMP management application using
the string can get and set object values on the switch. The switch
can use the string to send notifications.
„ auth-type {none | md5 | sha} {auth-pass-phrase string |
auth-key hex-string} — Specifies the authentication type used to
authenticate communications with the remote SNMP engine. You can
specify one of the following:
„ none —No authentication is used.
„ md5
—Message-digest algorithm 5 is used.
„ sha —Secure Hashing Algorithm (SHA) is used.
If the authentication type is md5 or sha, you can specify a passphrase
or a hexadecimal key.
„
To specify a passphrase, use the auth-pass-phrase string option.
The string can be from 8 to 32 alphanumeric characters long, with
no spaces.
„
To specify a key, use the auth-key hex-string option.
„ encrypt-type {none | des | 3des | aes}
{encrypt-pass-phrase string | encrypt-key hex-string} —
Specifies the encryption type used for SNMP traffic. You can specify
one of the following:
„ none —No encryption is used. This is the default.
„ des
—Data Encryption Standard (DES) encryption is used.
„ 3des
—Triple DES encryption is used.
„ aes —Advanced Encryption Standard (AES) encryption is used.
If the encryption type is des, 3des, or aes, you can specify a
passphrase or a hexadecimal key.
„
To specify a passphrase, use the encrypt-pass-phrase string
option. The string can be from 8 to 32 alphanumeric characters
long, with no spaces.
„
To specify a key, use the encrypt-key hex-string option.