3Com WXR100 3CRWXR10095A - Manual (Page 579)

set igmp qi 579
set igmp qi Changes the IGMP query interval timer on one VLAN or all VLANs on a
WX.
Syntax — set igmp qi seconds [vlan vlan-id]
„ qi seconds — Number of seconds that elapse between general
queries sent by the WX when the WX switch is the querier for the
subnet. You can specify a value from 1 through 65,535.
„ vlan vlan-id
— VLAN name or number. If you do not specify a
VLAN, the timer change applies to all VLANs.
Defaults — The default query interval is 125 seconds.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The query interval is applicable only when the WX is querier for
the subnet. For the WX switch to become the querier, the pseudo-querier
feature must be enabled on the WX and the WX must have the lowest IP
address among all the WX switches eligible to become a querier. To
enable the pseudo-querier feature, use the set igmp querier command.
Examples — The following command changes the query interval on
VLAN orange to 100 seconds:
WX1200# set igmp qi 100 vlan orange
success: change accepted.
See Also
„
set igmp lmqi on page 574
„
set igmp oqi on page 577
„
set igmp qri on page 580
„
set igmp querier on page 581
„
set igmp mrouter on page 575
„
set igmp rv on page 582