3Com WXR100 3CRWXR10095A - Manual (Page 84)

84 C HAPTER 1: U SING THE C OMMAND -L INE I NTERFACE
To see all the variations, type one of the commands followed by a
question mark (?). For example:
WX1200# display ip ?
alias display ip aliases
dns display DNS status
https display ip https
route display ip route table
telnet display ip telnet
To determine the port on which Telnet is running, type the following
command:
WX1200# display ip telnet
Server Status Port
----------------------------------
Enabled 23
Understanding
Command
Descriptions Each command description in the 3Com Mobility System Software
Command Reference contains the following elements:
„
A command name, which shows the keywords but not the variables.
For example, the following command name appears at the top of a
command description and in the index:
set ap name
„
A brief description of the command’s functions.
„
The full command syntax.
„
Any command defaults.
„
The command access, which is either enabled or all. All indicates that
anyone can access this command. Enabled indicates that you must
enter the enable password before entering the command.
„
The command history, which identifies the MSS version in which the command
was introduced and the version numbers of any subsequent updates.
„
Special tips for command usage. These are omitted if the command
requires no special usage.
„
One or more examples of the command in context, with the
appropriate system prompt and response.
„
One or more related commands.