3Com WXR100 3CRWXR10095A - Manual (Page 690)

690 C HAPTER 19: RF D ETECTION C OMMANDS
display rfdetect
data Displays all the BSSIDs detected by an individual WX switch during an RF
detection scan. The data includes BSSIDs transmitted by other 3Com
radios as well as by third-party access points.
Syntax —
display rfdetect data
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0. Vendor, Type, and Flag fields
added in MSS Version 4.0.
Usage — You can enter this command on any WX switch in the Mobility
Domain. The output applies only to the switch on which you enter the
command. To display all devices that a specific 3Com radio has detected,
even if the radio is managed by another WX switch, use the display
rfdetect visible command.
To display rogue information for the entire Mobility Domain, use the
display rfdetect mobility-domain command on the seed switch.
Only one MAC address is listed for each 3Com radio, even if the radio is
beaconing multiple SSIDs.
Examples — The following command shows the devices detected by this
WX switch during the most recent RF detection scan:
WX1200# display rfdetect data
Total number of entries: 7
BSSID Port/Rad Chan RSSI Age SSID
----------------- -------- ------ ---- --- --------
00:06:25:09:39:4a 5/1 3 0 15 rack29-hostap
00:06:25:51:e9:ff 4/1 10 -85 15 Arrow
00:06:25:51:e9:ff 5/1 10 -84 15 Arrow
00:0b:0e:00:00:00 4/1 1 -78 15 gary-eng
00:0b:0e:00:02:00 4/1 11 -76 15 public
00:0b:0e:00:02:00 5/1 11 -74 15 public
00:0b:0e:00:02:01 4/1 56 -68 15 public
Table 107 describes the fields in this display.