3Com WXR100 3CRWXR10095A - Manual (Page 362)

362 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
Access — Enabled.
History — Introduced in MSS Version 3.0. Options added to clear SODA
parameters in Version 4.2.
Usage — If the service profile is mapped to a radio profile, you must
remove it from the radio profile first. (After disabling all radios that use
the radio profile, use the clear radio-profile name service-profile name
command.)
Examples — The following commands disable the radios using radio
profile rp6, remove service-profile svcprof6 from rp6, then clear svcprof6
from the configuration.
WX4400# set radio-profile rp6 mode disable
WX4400# clear radio-profile rp6 service-profile svcprof6
success: change accepted.
WX4400# clear service-profile svcprof6
success: change accepted.
See Also
„
clear radio-profile on page 360
„
display service-profile on page 401
„
set radio-profile mode on page 464
display ap arp Displays the ARP table for a specified MAP.
Syntax —
display ap arp ap-number
„ ap-number — Index value that identifies the MAP on the WX.
Defaults — None.
Access — All.
History — Introduced in MSS Version 6.0.