3Com WXR100 3CRWXR10095A - Manual (Page 230)

230 C HAPTER 7: IP S ERVICES C OMMANDS
Defaults — The default Telnet port number is 23.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the Telnet port number
on a WX to 5000:
WX4400# set ip telnet 5000
success: change accepted.
See Also
„
clear ip telnet on page 189
„
display ip https on page 203
„
display ip telnet on page 206
„
set ip https server on page 225
„
set ip telnet server on page 230
set ip telnet server Enables the Telnet server on a WX.
CAUTION: If you disable the Telnet server, Telnet access to the WX is also
disabled.
Syntax — set ip telnet server {enable | disable}
„ enable — Enables the Telnet server.
„ disable
— Disables the Telnet server.
Defaults — The Telnet server is disabled by default.
Access — Enabled.
Usage — The maximum number of Telnet sessions supported on a WX is
eight. If SSH is also enabled, the WX can have up to eight Telnet or SSH
sessions, in any combination, and one console session.
Examples — The following command enables the Telnet server on a WX:
WX4400# set ip telnet server enable
success: change accepted.