3Com WXR100 3CRWXR10095A - Manual (Page 514)

514 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
set service-profile
ssid-type Specifies whether the SSID managed by a service profile is encrypted or
unencrypted.
Syntax — set service-profile name ssid-type [clear | crypto]
„ name — Service profile name.
„ clear
— Wireless traffic for the service profile’s SSID is not encrypted.
„ crypto
— Wireless traffic for the service profile’s SSID is encrypted.
Defaults — The default SSID type is crypto.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the SSID type for service
profile clear_wlan to clear:
WX4400# set service-profile clear_wlan ssid-type clear
success: change accepted.
See Also
„
display service-profile on page 401
„
set service-profile ssid-name on page 513
set service-profile
tkip-mc-time Changes the length of time that MAP radios use countermeasures if two
message integrity code (MIC) failures occur within 60 seconds. When
countermeasures are in effect, MAP radios dissociate all TKIP and WPA
WEP clients and refuse all association and reassociation requests until the
countermeasures end.
Syntax —
set service-profile name tkip-mc-time wait-time
„ name
— Service profile name.
„ wait-time — Number of milliseconds (ms) countermeasures remain in
effect. You can specify from 0 to 60,000.
Defaults — The default countermeasures wait time is 60,000 ms (60
seconds).
Access — Enabled.