3Com WXR100 3CRWXR10095A - Manual (Page 89)

3 S
YSTEM
S
ERVICE
C
OMMANDS
Use system services commands to configure and monitor system
information for a WX switch.
Commands by
Usage This chapter presents system service commands alphabetically. Use
Table 7 to locate commands in this chapter based on their use.
Table 7 System Services Commands by Usage
Type Command
Configuration quickstart on page 100
Auto-Config set auto-config on page 100
Display clear banner motd on page 90
quickstart on page 100
display banner motd on page 93
set banner acknowledge on page 102
set confirm on page 105
set length on page 105
System Identification set prompt on page 107
set system name on page 116
set system location on page 115
set system contact on page 108
set system countrycode on page 109
set system idle-timeout on page 113
set system idle-timeout on page 113
display load on page 95
display system on page 95