Set dot1x port-control – 3Com WXR100 3CRWXR10095A User Manual
Page 654
654
C
HAPTER
17: 802.1X M
ANAGEMENT
C
OMMANDS
set dot1x
port-control
Determines the 802.1X authentication behavior on individual wired
authentication ports or groups of ports.
Syntax —
set dot1x port-control
{forceauth
| forceunauth | auto} port-list
forceauth
— Forces the specified wired authentication port(s) to
unconditionally authorize all 802.1X authentication attempts, with an
EAP success message.
forceunauth
— Forces the specified wired authentication port(s) to
unconditionally reject all 802.1X authentication attempts with an EAP
failure message.
auto
— Allows the specified wired authentication ports to process
802.1X authentication normally as determined for the user by the set
authentication dot1X command.
port-list
— One or more wired authentication ports for which to
set 802.1X port control.
Defaults — By default, wired authentication ports are set to auto.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command affects only wired authentication ports.
Examples — The following command forces port 1 to unconditionally
accept all 802.1X authentication attempts:
WX4400# set dot1x port-control forceauth 1
success: authcontrol for 1 is set to FORCE-AUTH.
See Also
display port status on page 127