3Com WXR100 3CRWXR10095A - Manual (Page 147)

set port type ap 147
This command does not apply to any gigabit Ethernet ports or to ports 7
and 8 on the WX1200 switch or port 3 on the WX2200 switch.
To manage a MAP access point on a switch model that does not have
10/100 Ethernet ports, use the set ap command to configure a
Distributed MAP connection on the switch.
Examples — The following command sets ports 1 through 3 and port 5
for MAP access point model AP2750 and enables PoE on the ports:
WX1200# set port type ap 1-3,5 model ap2750 poe enable
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
The following command sets ports 1 through 3 and port 5 for MAP
access point model AP7250 and enables PoE on the ports:
WX1200# set port type ap 1-3,5 model ap7250 poe enable
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
The following command sets ports 1 through 3 and port 5 for MAP
access point model AP8250 and enables PoE on the ports:
WX1200# set port type ap 1-3,5 model ap8250 poe enable
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
The following command sets ports 1 through 3 and port 5 for MAP
access point model AP8750 and enables PoE on the ports:
WX1200# set port type ap 1-3,5 model ap8750 poe enable
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
The following command resets port 5 by clearing it:
WX1200# clear port type 5
This may disrupt currently authenticated users.
Are you sure? (y/n) [n]y
success: change accepted.
IGMP snooping Enabled as users are authenticated and join VLANs.
Maximum user
sessions Not applicable
Table 18 MAP Access Port Defaults (continued)