3Com WXR100 3CRWXR10095A - Manual (Page 332)

332 C HAPTER 9: M OBILITY D OMAIN C OMMANDS
set
mobility-domain
member On the seed WX, adds a member to the list of Mobility Domain members.
If the current WX is not configured as a seed, this command is rejected.
Syntax — set mobility-domain member ip-addr Key hex-bytes
„ ip-addr — IP address of the Mobility Domain member in dotted
decimal notation.
„ Key hex-bytes — Fingerprint of the public key to use for WX-WX
security. Specify the key as 16 hexadecimal bytes. Use a colon
between each byte, as in the following example:
00:11:22:33:44:55:66:77:88:99:aa:bb:cc:dd:ee:ff.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command must be entered from the seed WX.
Examples — The following commands add three WX switches with the
IP addresses 192.168.1.8, 192.168.1.9, and 192.168.1.10 as members of
a Mobility Domain whose seed is the current WX:
WX4400# set mobility-domain member 192.168.1.8
success: change accepted.
WX4400# set mobility-domain member 192.168.1.9
success: change accepted.
WX4400# set mobility-domain member 192.168.1.10
success: change accepted.
See Also
„
clear mobility-domain member on page 328
„
display mobility-domain config on page 330
„
set mobility-domain mode seed domain-name on page 336