3Com WXR100 3CRWXR10095A - Manual (Page 441)

set ap radio tx-power 441
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option auto added for
configuration of the MAP configuration profile. Version 6.0 removed the
dap option.
Usage — When you create a new profile, the radio parameters in the
profile are set to their factory default values.
To enable or disable all radios using a specific radio profile, use set
radio-profile.
Examples — The following command enables radio 1 on MAP 5
assigned to radio profile rp1:
WX1200# set ap 5radio 1 radio-profile rp1 mode enable
success: change accepted.
See Also
„
clear ap radio on page 356
„
display radio-profile on page 398
„
set ap radio mode on page 439
„
set radio-profile mode on page 464
set ap radio
tx-power Sets the transmit power of a MAP radio.
Syntax — set ap ap-number radio {1 | 2} tx-power power-level
„ ap ap-number — Index value that indentifies the MAP on the WX.
„ radio 1
— Radio 1 of the MAP.
„ radio 2
— Radio 2 of the MAP. (This option does not apply to
single-radio models.)
„ tx-power power-level
— Number of decibels in relation to
1 milliwatt (dBm). The valid values depend on the country of
operation.
The maximum transmit power you can configure on any 3Com radio
is the maximum allowed for the country in which you plan to operate
the radio or one of the following values if that value is less than the