3Com WXR100 3CRWXR10095A - Manual (Page 356)

356 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
clear ap radio Disables a MAP radio and resets it to its factory default settings.
Syntax —
clear ap ap-num } radio {1 | 2 | all}
„ ap ap-number
— Index value that identifies the MAP on the WX.
„ radio 1 — Radio 1 of the MAP.
„ radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
„ radio all
— All radios on the MAP.
Defaults — The clear ap radio command resets the radio to the default
settings listed in Table 52 and in Table 73 on page 464.
Table 52 Radio-Specific Parameters
Parameter Default Value Description
antennatype For most MAP models, the
default is internal.
The default for the
802.11b/g radio on model
AP3150 is ANT1060.
External antenna model
Note: This parameter is
configurable only on MAPs
that support external
antennas.
auto-tune
„
max-power—highest
setting allowed for the
country of operation or
highest setting
supported on the
hardware, whichever is
lower
„
max-retransmissions—
10 percent
„
min-client-rate—5.5 Mb
ps for 802.11b/g;
24 Mbps for 802.11b/g
„
RF Auto-Tuning settings:
„ max-power—maximum
power that RF Auto-Tuning
can set on a radio
„
max-retransmissions—ma
ximum percentage of
client retransmissions a
radio can experience
before RF Auto-Tuning
considers changing the
channel on the radio
„
min-client-rate—minimum
rate at which a radio is
allowed to transmit traffic
to clients
channel „ 802.11b — 6
„
802.11a — Lowest
valid channel number
for the country of
operation
Number of the channel in
which a radio transmits and
receives traffic
mode
„
disable Operational state of the
radio.