3Com WXR100 3CRWXR10095A - Manual (Page 739)

21 T
RACE
C
OMMANDS
Use trace commands to perform diagnostic routines. While MSS allows
you to run many types of traces, this chapter describes commands for
those traces you are most likely to use. For a complete listing of the types
of traces MSS allows, type the set trace ? command.
CAUTION: Using the set trace command can have adverse effects on
system performance. 3Com recommends that you use the lowest levels
possible for initial trace commands, and slowly increase the levels to get
the data you need.
Commands by
Usage This chapter presents trace commands alphabetically. Use Table 117 to
locate commands in this chapter based on their use.
Table 117 Trace Commands by Usage
Type Command
Trace set trace sm on page 745
set trace dot1x on page 744
set trace authentication on page 742
set trace authorization on page 743
display trace on page 741
save trace on page 742
clear trace on page 740
clear log trace on page 740