3Com WXR100 3CRWXR10095A - Manual (Page 453)

set radio-profile auto-tune channel-lockdown 453
Examples — The following command sets the channel interval for radios
in radio profile rp2 to 2700 seconds (45 minutes):
WX4400# set radio-profile rp2 auto-tune channel-interval 2700
success: change accepted.
See Also
„
display radio-profile on page 398
„
set radio-profile auto-tune channel-config on page 450
„
set radio-profile auto-tune channel-holddown on page 451
set radio-profile
auto-tune
channel-lockdown Locks down the current channel settings on all radios in a radio profile.
The
channel settings that are in effect when the command is entered
are changed into statically configured channel assignments on the
radios. RF Auto-Tu
ning of channels is then disabled in the radio profile.
Syntax — set radio-profile name auto-tune channel-lockdown
„ name
— Radio profile name.
Defaults — By default, when RF Auto-Tuning of channels is enabled,
channels continue to be changed dynamically based on network
conditions.
Access — Enabled.
History —Introduced in MSS Version 5.0.
Usage — To save this command and the static channel configuration
commands created when you enter this command, save the
configuration.