3Com WXR100 3CRWXR10095A - Manual (Page 454)

454 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
Examples — The following command locks down the channel settings
for radios in radio profile rp2:
WX# set radio-profile rp2 auto-tune channel-lockdown
success: change accepted
See Also
„
display radio-profile on page 398
„
set radio-profile auto-tune channel-config on page 450
„
set radio-profile auto-tune channel-holddown on page 451
„
set radio-profile auto-tune channel-interval on page 452
„
set radio-profile auto-tune channel-config on page 450
set radio-profile
auto-tune
power-config Enables or disables dynamic power tuning (RF Auto-Tuning) for the MAP
radios in a radio profile.
Syntax —
set radio-profile name auto-tune power-config
{enable | disable}
„ name
— Radio profile name.
„ enable
— Configures radios to dynamically set their power levels
when the MAPs are started.
„ disable
— Configures radios to use their statically assigned power
levels, or the default power levels if unassigned, when the radios are
started.
Defaults — Dynamic power assignment is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — When RF Auto-Tuning for power is disabled, MSS does not
dynamically set the power levels when radios are first enabled and also
does not tune power during operation with associated clients.
When RF Auto-Tuning for power is enabled, MSS does not allow you to
manually change the power level.