3Com WXR100 3CRWXR10095A - Manual (Page 479)

set service-profile attr 479
Usage — U-APSD is supported only for QoS mode WMM. If WMM is not
enabled on the radio profile, use the set radio-profile qos-mode
command to enable it.
Examples — The following command enables U-APSD on radio profile
rp1:
WX2200# set radio-profile rp1 wmm-powersave enable
success: change accepted.
See Also
„
set radio-profile mode on page 464
„
set radio-profile qos-mode on page 468
„
display radio-profile on page 398
set service-profile
attr Configures authorization attributes that are applied by default to users
accessing the SSID managed by the service profile. These SSID default
attributes are applied in addition to any supplied by the RADIUS server or
from the local database.
Syntax — set service-profile name attr attribute-name value
„ name — Service profile name.
„ attribute-name value — Name and value of an attribute you are
using to authorize SSID users for a particular service or session
characteristic. For a list of authorization attributes and values that you
can assign to network users, see Table 45 on page 310. All of the
attributes listed in Table 45 can be used with this command except
ssid.
Defaults — By default, a service profile does not have any authorization
attributes set.
Access — Enabled.
History —Introduced in MSS 4.1.
Usage — To change the value of a default attribute for a service profile,
use the set service-profile attr command and specify a new value.