3Com WXR100 3CRWXR10095A - Manual (Page 317)

set mobility-profile 317
set mobility-profile Creates a Mobility Profile and specifies the MAP access point and/or wired
authentication ports on the WX switch through which any user assigned
to the profile is allowed access.
Syntax —
set mobility-profile name name {port {none | all |
port-list}} | {ap {none | all | ap-num}}
„ name — Name of the Mobility Profile. Specify up to 32 alphanumeric
characters, with no spaces.
„ none — Prevents any user to whom this profile is assigned from
accessing any MAP access point or wired authentication port on the
WX switch.
„ all — Allows any user to whom this profile is assigned to access all
MAP access ports and wired authentication port on the WX switch.
„ port-list — List of MAP access ports or wired authentication ports
through which any user assigned this profile is allowed access. The
same port can be used in multiple Mobility Profile port lists.
„ ap-num — List of Distributed MAP connections through which any
user assigned this profile is allowed access. The same Distributed MAP
can be used in multiple Mobility Profile port lists.
Defaults — No default Mobility Profile exists on the WX. If you do not
assign Mobility Profile attributes, all users have access through all ports,
unless denied access by other AAA servers or by access control lists
(ACLs).
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — To assign a Mobility Profile to a user or group, specify it as an
authorization attribute in one of the following commands:
set user attr mobility-profile name
set usergroup attr mobility-profile name
set mac-user attr mobility-profile name
set mac-usergroup attr mobility-profile name
To enable the use of the Mobility Profile feature on the WX switch, use
the set mobility-profile mode command.