3Com WXR100 3CRWXR10095A - Manual (Page 632)

632 C HAPTER 16: RADIUS AND S ERVER G ROUP C OMMANDS
See Also
„
clear radius server on page 629
„
display aaa on page 277
„
set radius server on page 635
set radius client
system-ip Causes all RADIUS requests to be sourced from the IP address specified by
the set system ip-address command, providing a permanent source IP
address for RADIUS packets sent from the WX switch.
Syntax —
set radius client system-ip
Defaults — None. If you do not use this command, RADIUS packets
leaving the WX have the source IP address of the outbound interface,
which can change as routing conditions change.
Examples — Enabled.
History —Introduced in MSS Version 3.0.
Usage — The WX system IP address must be set before you use this
command.
Examples — The following command sets the WX system IP address as
the address of the RADIUS client:
WX4400# set radius client system-ip
success: change accepted.
See Also
„
clear radius client system-ip on page 627
„
set system idle-timeout on page 113