3Com WXR100 3CRWXR10095A - Manual (Page 777)

diag 777
Examples — The following command displays the current setting of the
DHCP option:
boot> dhcp
DHCP is currently enabled.
The following command disables the DHCP option:
boot> dhcp
DHCP is currently disabled.
See Also
„
boot on page 771
diag Accesses the diagnostic mode.
Syntax —
diag
Defaults — The diagnostic mode is disabled by default.
Access — Boot prompt.
History —Introduced in MSS Version 3.0.
Usage — Access to the diagnostic mode requires a password, which is
not user configurable. Use this mode only if advised to do so by 3Com.
dir Displays the boot code and system image files on a WX switch.
Syntax — dir [c: | d: | e: | f: | boot0 | boot1]
„ c: — Nonvolatile storage area containing boot partition 0 (primary).
„ d:
— Nonvolatile storage area containing boot partition 1 (secondary).
„ e: — Primary partition of the flash card in the flash card slot.
„ f: — Secondary partition of the flash card in the flash card slot.
„ boot0
— Boot partition 0.
„ boot1
— Boot partition 1.
Defaults — None.