3Com WXR100 3CRWXR10095A - Manual (Page 214)

214 C HAPTER 7: IP S ERVICES C OMMANDS
Examples — To display the offset from UTC, type the following
command:
WX4400# display timezone
Timezone set to 'pst', offset from UTC is -8 hours
See Also
„
clear summertime on page 193
„
clear timezone on page 194
„
display summertime on page 212
„
display timedate on page 213
„
set summertime on page 250
„
set timedate on page 252
„
set timezone on page 253
ping Tests IP connectivity between a WX and another device. MSS sends an
Internet Control Message Protocol (ICMP) echo packet to the specified
device and listens for a reply packet.
Syntax — ping host [count num-packets ] [dnf] [flood]
[interval time] [size size] [source-ip ip-addr | vlan-name]
„ host
— IP address, MAC address, hostname, alias, or user to ping.
„ count num-packets — Number of ping packets to send. You can
specify from 0 through 2,147,483,647. If you enter 0, MSS pings
continuously until you interrupt the command.
„ dnf — Enables the Do Not Fragment bit in the ping packet to prevent
fragmenting the packet.
„ flood — Sends new ping packets as quickly as replies are received, or
100 times per second, whichever is greater.
Use the flood option sparingly. This option creates a lot of traffic and can
affect other traffic on the network.
„ interval time
— Time interval between ping packets, in
milliseconds. You can specify from 100 through 10,000.
„ size size — Packet size, in bytes. You can specify from 56 through
65,507.