Set band-preference – 3Com WXR100 3CRWXR10095A User Manual
Page 445
set band-preference
445
set band-preference
Configures MSS to steer clients that support both the 802.11a and
802.11b/g radio bands to a specific radio on an MAP for the purpose of
RF load balancing.
Syntax —
set band-preference {none | 11bg | 11a}
none
— When a client supports both 802.11a and 802.11b/g radio
bands, does not steer the client to a specific MAP radio.
enable
— When a client supports both 802.11a and 802.11b/g radio
bands, steers the client to the 802.11b/g radio.
disable
— When a client supports both 802.11a and 802.11b/g
radio bands, steers the client to the 802.11a radio.
Defaults — By default, clients are not steered to specific MAP radios for
RF load balancing.
Access — Enabled.
History
—
Introduced in MSS Version 6.0.
Usage
—
Use this command to steer clients that support both the
802.11a and
802.11b/g bands, to a specific radio on an MAP for the
purpose of load balancing. This global band-preference option controls
the degree that an MAP with two radios attempts to conceal one of its
radios from a client with the purpose of steering the client to the other
radio.
Examples
—
The following command steers clients that support both
the 802.11a
and 802.11b/g bands to the 802.11a radio on an MAP:
WX# set band-preference 11a
WX#
See Also
display load-balancing group on page 396
set load-balancing mode on page 446
set load-balancing strictness on page 447