3Com WXR100 3CRWXR10095A - Manual (Page 492)

492 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
To support non-WPA clients that use static WEP, you must configure static
WEP keys. Use the set service-profile wep key-index command.
Examples — The following command configures service profile sp2 to
use 40-bit WEP encryption:
WX4400# set service-profile sp2 cipher-wep40 enable
success: change accepted.
See Also
„
display service-profile on page 401
„
set service-profile cipher-ccmp on page 488
„
set service-profile cipher-tkip on page 489
„
set service-profile cipher-wep104 on page 490
„
set service-profile wep key-index on page 528
„
set service-profile wpa-ie on page 529
set service-profile
cos Sets the Class-of-Service (CoS) level for static CoS.
Syntax —
set service-profile name cos level
„ name
— Service profile name.
„ level — CoS value assigned by the MAP to all traffic in the service
profile.
Defaults — The default static CoS level is 0.
Access — Enabled.
History —Introduced in MSS Version 4.2.
Usage — This command applies only when static CoS is enabled. If static
CoS is disabled, prioritization is based on the QoS mode configured in the
radio profile, and on any ACLs that set CoS. (See the “Configuring
Quality of Service” chapter of the
Wireless LAN Switch and Controller
Configuration Guide .) To enable static CoS, use the set service-profile
static-cos command.
Examples — The following command changes the static CoS level to 7
(voice priority):