IAI America XSEL-KET User Manual
Page 356
337
Appendix
INTELLIGENT ACTUATOR
I/O Parameters
No. Parameter
name
Default value
(Reference)
Input range
Unit
Remarks
13 Expanded I/O3 error
monitor (I/O4)
1
0 ~ 5
0: Do not monitor
1: Monitor
2: Monitor (Do not monitor errors relating to 24-V
I/O power source)
(Main application version 0.55 or later)
3: Monitor (Monitor only errors relating to 24-V I/O
power source)
(Main application version 0.55 or later)
* Some exceptions apply.
14 Number
of
ports
using network-I/F-
card remote input
0
0 ~ 256
Refer to the operation manual for each network I/F
card (CC-Link, DeviceNet, etc.).
15 Number
of
ports
using network-I/F-
card remote output
0
0 ~ 256
Refer to the operation manual for each network I/F
card (CC-Link, DeviceNet, etc.).
16 (For
future
extension
= Change prohibited)
0
0 ~ 256
Multiple of 8
17 (For
future
extension
= Change prohibited)
0
0 ~ 256
Multiple of 8
18~
19
(For extension)
0
20 Input filtering periods
2
1 ~ 9
msec
Input signal is recognized when the status is held for
twice the period set by this parameter.
21 Register
input
filtering periods
2
1 ~ 9
msec
Input signal is recognized when the status is held for
twice the period set by this parameter.
22 Remote-I/O-card
fieldbus ready
timeout value
2000
0 ~ 99999
msec
Timeout check is not performed if “0” is set.
23 Multi-point
DIO
external terminal
block overcurrent
Power-supply error
detection input
specification
0H
0H ~ FFFFFFFFH
Bits 0 to 3:
For future extension.
Bits 4 to 7:
Expansion I/O1 (I/O2) input specification
Bits 8 to 11:
Expansion I/O2 (I/O3) input specification
Bits 12 to 15: Expansion I/O3 (I/O4) input specification
(0: No error detection input
1: Error detection input = IN023 in the
card
2: Error detection input = IN047 in the
card
3: Error detection input = IN023/47 in
the card)
* Set this parameter after confirming the
specification of the multi-point DIO terminal block
unit to be connected.
* The input port used as an error detection input
cannot be used as a general-purpose input port.
* Be sure to specify “0” (No error detection input) if
the main application version is 0.82 or earlier.