IAI America XSEL-KET User Manual
Page 424
Appendi
x
INTELLI
GENT A
CTUAT
OR
405
(In the panel window, the three digits after “E” indicate an error number.)C
Error No.
Error name
Description, action, etc.
A84
Code sector block ID erase count over
The number of times the flash ROM was erased exceeded the allowable
count.
A85
FROM write request error before erase is complete
When updating, a flash-ROM write command was received before a flash-
ROM erase command. Confirm that the update program file is valid and
then perform update again.
A86
Absolute-encoder backup battery voltage-low warning
(Driver detection)
The voltage of the absolute-data backup battery is low. Check the battery
connection or replace the battery.
A87
Motorola S byte count error (Core detection)
The update program file is invalid. Check the file.
A88
Message conversion error (Core detection)
The received message does not match the message format or contains
invalid data. Check the message sent from the host communication device.
A89
Update target non-specification error (Core detection)
When an update was attempted, an update command was received before
the update target was specified correctly. Check if an appropriate update
PC tool is used and the target specification and other settings of the update
PC tool are correct.
A8A
Update system code error (Core detection)
The system code in the received update target specification command
message does not match the controller system. Check the target
specification and other settings of the update PC tool.
A8B
Update unit code error (Core detection)
The unit code in the received update target specification command
message does not match the controller system. Check the target
specification and other settings of the update PC tool.
A8C
Update device number error (Core detection)
The value of device number specified in the received update target
specification command message is not appropriate. Check the target
specification, device number and other settings of the update PC tool.
A8D
Flash busy reset timeout (Core detection)
Flash ROM clear or write error.
A8E
Unit type error (Core detection)
The unit type in the received command message is invalid or not supported.