IAI America XSEL-KET User Manual
Page 384
365
Appendix
INTELLIGENT ACTUATOR
Other Parameters
No. Parameter
name
Default value
(Reference)
Input range
Unit
Remarks
45 Special
start
condition setting
0 0H
~
FFFFFFFFH
Bits 0 to 3:
Enable start from PC/TP in AUTO
mode = Used exclusively by the
manufacturer (0: Do not enable, 1:
Enable) (Main application version
0.36 or later)
Bits 4 to 7:
PIO program start (Input port 000)
Single start selection (0: Normal, 1:
Single start)
* When single start is selected, the
next PIO program start (input port
000) will not be accepted as long
as a program with the same
program number as the one
started by the last PIO program
start (input port 000) is running.
(Main application version 0.52 or
later)
Bits 8 to 11: Permission of auto program start
when all-operation-cancellation
factor is present
(0: Do not permit, 1: Permit)
(Main application version 0.79 or
later)
Bits 12 to 15: Permission of ON edge of PIO
program start (input port 000) when
all-operation-cancellation factor is
present
(0: Do not permit, 1: Permit)
* This parameter specifies an ON
edge acceptance condition and if the
start condition is not satisfied, “Error
No. A1E, Start condition non-
satisfaction error” will generate.
(Main application version 0.79 or
later)