Appendix, I/o parameters – IAI America XSEL-KET User Manual
Page 365
346
INTELLIGENT ACTUATOR
Appendix
I/O Parameters
No. Parameter
name
Default value
(Reference)
Input range
Unit
Remarks
128 Network
attribute 9
0H
0H ~ FFFFFFFFH
Ethernet TCP/IP message communication attribute
Bits 0 to 15: SEL server open timeout value (sec)
(No timeout check, if 0)
129 Network
attribute 10
0H
0H ~ FFFFFFFFH
Ethernet operation specification
Bits 0 to 3:
Modbus/TCP (remote I/O)
(0: Not used
1: Used
(Exception status invalid)
2: Used (Exception status (upper 2
digits of error number) valid)
* Select an appropriate processing
according to each error level by
referring to the explanation of
error levels in the operation
manual.
Bits 4 to 7:
TCP/IP message communication
(0: Not used, 1: Used)
Bits 8 to 31: Reserved (operation specification)
130 Own MAC address (H)
0H
Referency only
(HEX)
Only lower two bytes are valid.
131 Own MAC address (L)
0H
Reference only
(HEX)
132 Own IP address (H)
192
0 ~ 255
* Setting of 0 and 127 is prohibited.
133 Own IP address (MH)
168
0 ~ 255
134 Own IP address (ML)
0
0 ~ 255
135 Own IP address (L)
1
0 ~ 254
* Setting of 0 and 255 is prohibited.
136 Subnet mask (H)
255
0 ~ 255
137 Subnet mask (MH)
255
0 ~ 255
138 Subnet mask (ML)
255
0 ~ 255
139 Subnet mask (L)
0
0 ~ 255
140 Default gateway (H)
0
0 ~ 255
141 Default gateway (MH)
0
0 ~ 255
142 Default gateway (ML)
0
0 ~ 255
143 Default gateway (L)
0
0 ~ 255
144 IAI protocol B/TCP: Own
port number (MANU mode)
64511 1025
~
65535
145 User-open channel 31
(TCP/IP): Own port number
64512 1025
~
65535
146 User-open channel 32
(TCP/IP): Own port number
64513 1025
~
65535
147 User-open channel 33
(TCP/IP): Own port number
64514 1025
~
65535
* Important: Be sure to set a different number for
each own port number. (Duplication is permitted
only for own port numbers under IAI protocol
B/TCP in the MANU/AUTO modes.)
148 User-open channel 34
(TCP/IP): Own port number
64515 1025
~
65535
149 IAI protocol B/TCP: IP
address of connection
destination (MANU mode)
(H)
192 0
~
255
* Setting of 0 and 127 is prohibited.