IAI America XSEL-KET - Manual (Page 78)

59
INTELLIGENT ACTUATOR
Part 1 Installation
Battery Replacement Procedure
1) Remove the 7-segment LED panel from the
controller. Slide the panel upward and pull it toward
you to remove.
2) As shown at left, remove the battery from the
holder using two screwdrivers, and then install a
new battery in the holder.
Gently lift the top (opening side) of the battery, and
then push out the bottom (closing side) to remove
the battery.
3) Install the panel in the original position.
8. When the replacement of system-memory backup battery is complete, confirm that the battery is
installed securely and then turn on the controller power.
9. Revert “Other parameter No. 20, Backup-battery installation function type” to the value recorded in
step 2, transfer the setting to the controller, and then perform a flash ROM write.
* Confirm that the flash ROM writing process has completed.
10. Perform a software reset (restart the controller).
11. When the controller has been restarted, confirm that the SRAM data have been restored.