H3C Technologies H3C SecPath F1000-E - Manual (Page 281)

3
Figure 2 Create a static route
Table 1 describes the static route configuration items.
Table 1 Static route configuration items
Item Remarks
Destination
Type the destination IP address in dotted decimal
notation
Mask Type the destination IP address mask
Next Hop
Type the next hop IP address in dotted decimal
notation
Interface Type the outbound interface
Priority
Type the static route priority
The static route priority defaults to 60.
Static Route Configuration Example
Network requirements
Configure IP addresses and masks for the interfaces and hosts as shown in Figure 3 . It is required to
configure static routes between the hosts so that any two hosts can communicate with each other.