Verify the configuration – H3C Technologies H3C SecPath F1000-E User Manual
Page 324
29
•
Click Apply.
# Configure Device C.
•
Select Network > Routing Management > OSPF from the navigation tree of Device C.
•
Select the Enable OSPF check box.
•
Select the Import static routes check box.
•
Click Apply.
•
Click Add on the Area Configuration tab.
•
Type 1 for Area ID.
•
Select NSSA for Area Type.
•
Type 10.2.1.0 for Network Address, and select 0.0.0.255 for Network Mask. Then, click
Add Network.
•
Type 10.4.1.0 for Network Address, and select 0.0.0.255 for Network Mask. Then, click
Add Network.
•
Click Apply.
•
Select Network > Static Route from the navigation tree and click Add.
•
Type 3.2.1.1 as the destination IP address.
•
Select 255.255.255.0 from the mask drop-down list.
•
Type 10.4.1.2 as the nexthop.
•
Click Apply.
# Configure Device D.
•
Select Network > Routing Management > OSPF from the navigation tree of Device D.
•
Select the Enable OSPF check box.
•
Click Apply.
•
Click Add on the Area Configuration tab.
•
Type 2 for Area ID.
•
Select Normal for Area Type.
•
Type 10.3.1.0 for Network Address, and select 0.0.0.255 for Network Mask. Then, click
Add Network.
•
Type 10.5.1.0 for Network Address, and select 0.0.0.255 for Network Mask. Then, click
Add Network.
•
Click Apply.
Verify the configuration
# Display neighbor information of Device A.
Select Network > Routing Management > OSPF from the navigation tree of Device A, and then
click Show Peer in the Show Information field. A neighbor in Full state is displayed in area 0 and
area 1 respectively, as shown in
. (192.168.1.42 is the router ID of Device B, and 192.168.1.57
is the router ID of Device C.)