Configuration verification – H3C Technologies H3C SecPath F1000-E User Manual
Page 910
45
•
Type the virtual service name VS.
•
Type the IP address of the virtual service 61.159.4.100.
•
Select the mask 32 (255.255.255.255).
•
Select the protocol type TCP.
•
Type the port number 80.
•
Select the forwarding mode NAT.
•
Select the real service group HTTPGroup.
•
Select the Enable Virtual Service check box.
•
Click Apply.
Configuration verification
After the server runs normally for a period of time, you can display the statistics to verify the configuration
of load balancing.
•
Select High Reliability > Load Balance > Server Load Balance from the navigation tree,
and click the Statistics tab.
•
Click the virtual service name link of virtual service VS, and you can see the statistics on the
corresponding page, as shown in
.
Figure 48 Statistics
, you can see that the total number of connections of Server A, Server B and Server C is
in a ratio of 15:12:10, which is the same as that of the configured weights. Therefore, the server load
balancing function has taken effect.