H3C Technologies H3C SecPath F1000-E User Manual
Page 761
15
Figure 29 Add a P2MP GRE tunnel interface (Tunnel 0)
•
Type 0 in the Tunnel Interface text box.
•
Type IP address/mask 172.168.1.1/24.
•
Select Management from the Zone drop-down list. (Select a security zone according to your
network configuration.)
•
Type 11.1.1.1 as the tunnel source address.
•
Type 24 as the branch network address mask.
•
Type 10 as the tunnel entry aging time.
•
Select the check box before Enable Interface Backup, and select backup interface Tunnel1.
•
Click Apply.
# Configure a static route from Device A through interface Tunnel 0 to the branch network.
•
Select Network > Routing Management > Static Routing from the navigation tree and
then click Add to perform the configurations shown in
.
Figure 30 Add a static route from Device A through interface Tunnel 0 to the branch network
•
Type 192.168.12.0 as the destination IP address.