H3C Technologies H3C SecPath F1000-E User Manual
Page 770
24
•
Select Tunnel0 as the outbound interface.
•
Click Apply.
Step2
Configure Device B
# Configure an IPv4 address for each interface and assign the interfaces to security zones (omitted).
# Create a GRE over IPv4 tunnel interface.
•
Select VPN > GRE > GRE from the navigation tree and then click Add to perform the
configurations shown in
.
Figure 43 Add a GRE over IPv4 tunnel interface
•
Type 0 in the Tunnel Interface text box.
•
Type IP address/mask 192.168.22.2/24.
•
Select Management from the Zone drop-down list. (Select a security zone according to your
network configuration.)
•
Type the tunnel source IP address 11.1.1.2.
•
Type the tunnel destination IP address 11.1.1.1.
•
Type the GRE key 1.
•
Click Apply.
# Configure a static route from Device B through interface Tunnel 0 to the headquarters node.
•
Select Network > Routing Management > Static Routing from the navigation tree and
then click Add to perform the configurations shown in
.