Zilog Z80230 User Manual
Scc/escc
Advertising
Table of contents
Document Outline
- SCC/ESCC User Manual
- Table of Contents
- General Description
- Interfacing the SCC/ESCC
- SCC/ESCC Ancillary Support Circuitry
- Data Communication Modes
- Register Descriptions
- Introduction
- Write Registers
- Write Register 0 (Command Register)
- Write Register 1 (Transmit/Receive Interrupt and Data Transfer Mode Definition)
- Write Register 2 (Interrupt Vector)
- Write Register 3 (Receive Parameters and Control)
- Write Register 4 (Transmit/Receive Miscellaneous Parameters and Modes)
- Write Register 5 (Transmit Parameters and Controls)
- Write Register 6 (Sync Characters or SDLC Address Field)
- Write Register 7 (Sync Character or SDLC Flag)
- Write Register 7 Prime (ESCC only)
- Write Register 7 Prime (85C30 Only)
- Write Register 8 (Transmit Buffer)
- Write Register 9 (Master Interrupt Control)
- Write Register 10 (Miscellaneous Transmitter/Receiver Control Bits)
- Write Register 11 (Clock Mode Control)
- Write Register 12 (Lower Byte of Baud Rate Generator Time Constant)
- Write Register 13 (Upper Byte of Baud Rate Generator Time Constant)
- Write Register 14 (Miscellaneous Control Bits)
- Write Register 15 (External/Status Interrupt Control)
- Read Registers
- Read Register 0 (Transmit/Receive Buffer Status and External Status)
- Read Register 1
- Read Register 2
- Read Register 3
- Read Register 4 (ESCC and 85C30 Only)
- Read Register 5 (ESCC and 85C30 Only)
- Read Register 6 (Not on NMOS)
- Read Register 7 (Not on NMOS)
- Read Register 8
- Read Register 9 (ESCC and 85C30 Only)
- Read Register 10
- Read Register 11 (ESCC and 85C30 Only)
- Read Register 12
- Read Register 13
- Read Register 14 (ESCC and 85C30 Only)
- Read Register 15
- Application Notes
- Interfacing Z80® CPUs to the Z8500 Peripheral Family
- AN0096: The Z180 Interfaced with the SCC at 10 MHz
- AN0097: The Zilog® Datacom Family with the 80186 CPU
- SCC in Binary Synchronous Communications
- Serial Communication Controller (SCC): SDLC Mode of Operation
- Using SCC with Z8000 in SDLC Protocol
- AN0300: Boost Your System Performance Using the Zilog ESCC Controller
- AN006: Technical Considerations When Implementing Localtalk Link Access Protocol
- AN0075: On-Chip Oscillator Design
- Interfacing the ISCC to the 68000 and 8086
- Zilog SCC Z8030/Z8530 Questions and Answers
- Zilog ESCC Controller Questions and Answers
- Questions and Answers
- Customer Support
- Table of Contents