Metrohm viva 1.0 (process analysis) - Manual (Page 133)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Workplace
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 121
Start series (Shortcut: Ctrl G)
Start of the first determination of a sample series. The button is disabled
as soon as the first determination begins running. If the start can be trig-
gered, then it will be green, otherwise light gray.
Stop series (Shortcut: Ctrl S)
Immediate stop of the ongoing determination of a sample series. The but-
ton is enabled as soon as the first determination begins running. If the
stop can be triggered, then it will be red, otherwise light gray.
Interrupt run
Interrupts the ongoing determination of a sample series. The button is
active (dark gray) in the status BUSY (determination is running). The but-
ton is disabled (light gray) in all other cases. When [Hold] is pressed, this
button will be replaced in the display by [Cont].
However, [Hold] does not allow you to stop all partial steps of the CVS
command.
Continue run
Continue the ongoing determination of a sample series. The button is only
present in the status HOLD (determination interrupted). When [Cont] is
pressed, then this button will be replaced again in the display by [Hold].