Metrohm viva 1.0 (process analysis) - Manual (Page 707)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 695
Acoustic signal
on | off (Default value: off)
If this check box is activated, an acoustic signal will be emitted in addition
to the message.
Action
The actions can only be edited if monitoring is switched on.
If it is found during monitoring that the validity period has expired, then
one of the following actions will be triggered automatically during the
start test:
Selection Record message | Display message | Cancel
determination
Default value Display message
Record message
The message that the validity period has expired will be automatically
saved with the determination.
Display message
A message is displayed and you can select whether you want to con-
tinue the run or cancel it. If the run is continued then the message that
the validity period has expired will be automatically saved with the
determination.
Cancel determination
The determination is not started. The following message must be con-
firmed with [OK].
6.6 Dosing units subwindow
6.6.1 Dosing units - General
Subwindow: Configuration ▶ Dosing units
Dosing units subwindow
The Dosing units subwindow contains the table with all automatically
recognized dosing units. It can be shown in the Configuration program
part as a part of the configuration view or (if not present in the user inter-
face) in a separate window with View
▶ Quick access. The subwindow
can be enlarged and reduced as required; it can also be maximized.
Intelligent dosing units (IDU)
Intelligent dosing units have a data chip with stored data. When mounted
on intelligent devices, they are automatically recognized and stored in the
table of dosing units.