Metrohm viva 1.0 (process analysis) - Manual (Page 39)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 General program functions
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 27
Designation Description Commands
LP.TIM Time in s until the last measuring point in the measuring point list is reached CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
LP.TRN Transmission of the last measuring point of the measuring point list in % CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc
LPO Current absolute lift position in mm (entry when ending the command) LIFT
LST Start time of the loop command (Date/Time) CALL COND
CAL LOOP
Opt, LOOP
MA.CNT Intensity for maximum measured value in counts MEAS Opt
MA.MEA Maximum measured value in the unit of the measured value MEAS Opt
MA.TEM Temperature for the maximum measured value in °C MEAS Opt
MA.TIM Time in s until the maximum measured value is reached MEAS Opt
MA.TRN Transmission for maximum measured value in % MEAS Opt
MI.CNT Intensity for minimum measured value in counts MEAS Opt
MI.MEA Minimum measured value in the unit of the measured value MEAS Opt
MI.TEM Temperature with minimum measured value in °C MEAS Opt
MI.TIM Time for the minimum measured value in s MEAS Opt
MI.TRN Transmission for minimum measured value in % MEAS Opt
MTE Temperature measurement with sensor; 1 = on, 0 = off) CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
NMP Number of measuring points in measuring point list CAL MEAS
Opt, CVS,
MEAS Opt,
MEAS Opt
Conc, MEAS
TMF
OUT Number of outliers CAL LOOP Opt
OVE Value of the output at the end of the command. Direct controller/2-point control-
ler: 1 = active, 0 = inactive
PID/PWM: -100 to 100% (value of the analog output or the pulse frequency)
CONTROL