Metrohm viva 1.0 (process analysis) - Manual (Page 575)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 563
Identification Description
UNI Mapping unit which is defined for an IO port in the
configuration
[VAL] Value of the command variables (optional, i.e. 'Com-
mand name.Portname' = 'Command
name.Portname.VAL'). The value returned corre-
sponds to the status of the IO port after the com-
mand is exited.
5.5.2.11.4.2 ANALOG OUT - General
Tab: Method ▶ ANALOG OUT ▶ Properties... ▶ ANALOG OUT - 'Command
name' ▶ General
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Shows the instrument type.
Selection IO Controller
Default value IO Controller
5.5.2.11.4.3 ANALOG OUT - Analog outputs
Tab: Method ▶ ANALOG OUT ▶ Properties... ▶ ANALOG OUT - 'Command
name' ▶ Analog outputs
Command name
Name of the command.
Entry 25 characters