Metrohm viva 1.0 (process analysis) - Manual (Page 584)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
572 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
NOTE
If the not defined option is selected, then no ports can be selected in
the Stepping motors tab, because it is not known on which block this
instrument is referenced.
Even if a method is to be created independent of an instrument, an
instrument must still nevertheless be selected for the editing of the
block. One can however set the instrument name back to not defined
afterwards.
Device type
Shows the instrument type.
Selection Stepping Motor Controller
Default value Stepping Motor Controller
5.5.2.11.7.3 STEPPING MOTOR - Stepping motors
Tab: Method ▶ STEPPING MOTOR ▶ Properties... ▶ STEPPING MOTOR - 'Com-
mand name' ▶ Stepping motors
Table
The actuation of one stepping motor is parameterized in each line of the
Stepping motors table.
One port can not be used more than once within a block.
If a command block originates from a different instrument, the Port
description of which does not exist on the currently selected instrument,
then the affected lines will be displayed in red lettering.