Metrohm viva 1.0 (process analysis) - Manual (Page 38)

2.3 Formula editor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
26 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Designation Description Commands
HCR Largest current measuring range used:
1 = 224 mA | 2 = 20 mA | 3 = 2 mA | 4 = 200 µA | 5 = 20 µA | 6 = 2 µA |
7 = 200 nA | 8 = 20 nA | 9 = 2 nA | 10= 200 pA
CVS
IME Initial measured value (measured value before start conditions are processed) in
the unit of the measured value CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
ITE Initial temperature (temperature before start conditions are processed) in °C CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
IVE Value of the input at the end of the command CONTROL
IVS Value of the input at the start of the command CONTROL
LCO Loop counter = current number of completed runs, both of Repeat loops and
While loops CALL COND,
CAL LOOP
Opt, LOOP
LCR Lowest current measuring range used:
10= 200 pA | 9 = 2 nA | 8 = 20 nA | 7 = 200 nA | 6 = 2 µA | 5 = 20 µA |
4 = 200 µA | 3 = 2 mA | 2 = 20 mA | 2 = 224 mA
CVS
LP.CAx Calculated value x (1 - 3) for the last measuring point on the measuring point list MEAS Opt,
MEAS Opt
Conc
LP.CNT Intensity of the last measuring point on the measuring point list in counts CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc
LP.EXx External value x (1 - 3) for the last measuring point on the measuring point list MEAS Opt,
MEAS Opt
Conc
LP.MEA Measured value for the last measuring point of the measuring point list in the unit
of the measured value CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
LP.TEM Temperature for the last measuring point of the measuring point list in °C CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF