Metrohm viva 1.0 (process analysis) - Manual (Page 591)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 579
5.6.2.2 General - Data processing
Tab: Method ▶ Evaluation ▶ General ▶ Data processing
Smoothing
Measure for the curve smoothing used for the data processing. The higher
the smoothing that is selected, the more the measurement curves will be
smoothed.
Input range 1 - 20
Default value 1
Reversed peaks
on | off (Default value: off)
Reversed peaks are evaluated only if this check box is activated. Peaks that
exhibit a positive signal during measurement in cathode direction or a
negative signal during measurement in anode direction are referred to as
reversed peaks.
5.6.3 Evaluation - Substances
5.6.3.1 Substances - General
Subwindow section: Method ▶ Evaluation ▶ Substances
Application
The parameters of the substances that are to be determined are defined in
the Substances section. These are specific for each measuring command
with which the substances are to be determined. The measuring com-
mand is selected in the upper area of the dialog. Settings that have
already been made are retained when switching between different mea-
suring commands.
Selection of the measuring command
Measuring command
Selection list with all of the VA measuring commands with data acquisi-
tion defined in the method.
Selection 'VA measuring command'
Tabs
￭ Recognition
￭ Baselines