6 series end, Series end – Metrohm viva 1.0 (process analysis) User Manual
Page 405
■■■■■■■■■■■■■■■■■■■■■■
5 Method
viva 1.0 (for Process analysis)
■■■■■■■■
393
Parameters
Command name
Name of the command.
Entry
1 - 25 characters
Default value
Series start track
Live display
on | off (Default value: on)
If this check box is activated, then the track will be displayed in the live
display.
Command variables
The following command variables are generated by the SERIES START
command in the method run and can be used in formulas under the des-
ignation 'Command name.Variable identification':
Identifi-
cation
Description
BSY
Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
FIN
Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
5.5.2.2.6
SERIES END
Dialog window: Method
▶ SERIES END ▶ Properties... ▶ SERIES END - 'Command
name'
Start command for the series end track.
Appearance
The command has the following appearance:
Parameters
Command name
Name of the command.