Metrohm viva 1.0 (process analysis) - Manual (Page 586)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
574 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Absolute position
Move to an absolute position; in this case, the stepping motor moves
to the value defined by Distance/Angle.
End position
Move to final position of the stepping motor.
Reset
The terminal to which the motor is connected is reset. In this process,
the LEDs of the terminal will flash briefly, afterwards it may be neces-
sary to reference again.
Distance
Distance that is to be moved.
Only visible for a stepping motor of the Type = Linear drive.
Input range -214783647 - 214783647 mm
Default value 0 mm
Angle
Angle that is to be traveled.
Only visible for a stepping motor of the Type = Rotary drive.
Input range -214783647 - 214783647 °
Default value 0 °
NOTE
The direction of travel of the stepping motor depends on the algebraic
sign of the value for Distance or Angle:
￭
≥ 0: Travel in positive direction.
￭
< 0: Travel in negative direction.
Start delay
Waiting time in seconds or minutes until the triggered action is started.
Input range 0 - 999,999
Default value 0
Selection s | min
Default value s
Timeout
Time in seconds or minutes during which the action must have been run
through completely. If this does not take place after the expiration of the
maximum waiting time, then the stepping motor will be set to the
ERROR status.