Metrohm viva 1.0 (process analysis) - Manual (Page 554)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
542 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
The Sample data request dialog window, in which the sample parame-
ters selected in the command are requested, appears in the method run
during the processing of this command. The run continues to be stopped
until the entry is confirmed.
NOTE
If the sequence is not to be stopped, the REQUEST command can
be inserted in a normal track for which the Return immediately check
box is activated.
ID1 - ID16
on | off (Default value: off)
If a check box is activated, then the respective sample identifications ID1 -
ID16 will be requested. If other names are assigned for these variables in
the START command, then these names will be displayed in the Sample
data request dialog window as field titles.
NOTE
Text is selected as the default type for the ID1 - ID16 sample identifi-
cation. If you wish to enter numbers for these method variables that are
to be used for later calculations, then these variables must be switched
to the Number type on the Sample data variables tab in the START
command (see Chapter 5.5.2.2.2.4, page 385).
Sample type
on | off (Default value: off)
If this check box is activated, then the Sample type will be requested.
Sample position
on | off (Default value: off)
If this check box is activated, then the position of the sample on the rack
will be requested.
Sample amount
on | off (Default value: off)
If this check box is activated, then the Sample amount will be requested
(see Glossary, page 963).