Metrohm viva 1.0 (process analysis) - Manual (Page 565)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 553
5.5.2.10.5.2 SEQUENCE - Properties
Dialog window: Method ▶ SEQUENCE ▶ Properties... ▶ SEQUENCE - Sequence #
Command name
Name of the command.
Entry 25 characters
There is no limit to the number of commands that can be added to a
SEQUENCE command; these are displayed in the command table. It con-
tains information regarding Command type and Command name. The
table itself cannot be edited. The individual lines of the table can be edited
with a context-sensitive menu.
Moves the selected command up (changes the sequence).
Moves the selected command down (changes the sequence).
[New]
Opens the New command dialog window for the selection of the
desired command that is to be inserted at the end of the table (see Chap-
ter 5.2.4.2.1, page 356).
[Properties]
Opens the dialog window of the selected command (see Chapter
5.2.4.2.8, page 359).
[Delete]
Deletes the selected command.
Copy Copies the commands selected in the table to the clipboard.
Cut Deletes the commands selected in the table and copies them to the clipboard.
Paste Inserts the commands that were copied to the clipboard at the end of the table.
5.5.2.11 Process analysis commands
5.5.2.11.1 Process analysis commands - Overview
Menu item: Method ▶ Insert ▶ New command...
Commands for controllers that are controlled with process analysis
instruments.
The following commands can be selected: