Metrohm viva 1.0 (process analysis) - Manual (Page 542)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
530 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Identification Description
FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
5.5.2.9.4.2 SEND - Properties
Dialog window: Method ▶ SEND ▶ Properties... ▶ SEND - 'Command name'
Command name
Name of the command.
Entry 25 characters
Send event messages
All of the defined event messages that are listed in the table are sent
simultaneously. The table cannot be edited directly.
NOTE
A maximum of 10 event messages can be entered.
[New]
Opens the Send event message dialog window for entering a new
event message (see Chapter 5.5.2.9.4.3, page 530).
[Properties]
Opens the Send event message dialog window for editing the event
message selected in the table(see Chapter 5.5.2.9.4.3, page 530).
[Delete]
Deletes the selected event message.
5.5.2.9.4.3 SEND - Sending the event message
Dialog window: Method ▶ SEND ▶ Properties... ▶ [New]/ [Properties] ▶ Send event
message
Receiver
Selection of the receiver type.
Selection System | Command
Default value System
Selection
Selection of the recipient address. All of the command names already
defined in the method are available when Receiver = Command. This
field cannot be edited when Receiver = System.