Metrohm viva 1.0 (process analysis) - Manual (Page 590)

5.6 Evaluation subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
578 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Evaluation sections
The Evaluation subwindow is comprised of five sections that can be
selected with the following symbols on the left-hand toolbar:
The parameters valid for the editing of the acquired data for each com-
mand for all substances are defined in the General section (see Chapter
5.6.2, page 578).
The substances that are to be identified in the sample are defined in the
Substances section. They are specific for the selected command (see
Chapter 5.6.3, page 579).
The standard solutions are defined in the Standards section. They apply
globally for the entire method (see Chapter 5.6.4, page 586).
The calibration method and additional parameters for calibration are
defined in the Calibration section (see Chapter 5.6.5, page 589). These
parameters apply globally for the entire method.
Results and result outputs are defined in the Results section (see Chapter
5.6.6, page 597).
5.6.2 Evaluation - General
5.6.2.1 General - General
Subwindow section: Method ▶ Evaluation ▶ General
Application
The parameters that are to be used for the processing of the acquired
data are defined in the General section. These parameters must be set
separately for each VA measuring command.
Selection of the measuring command
Measuring command
Selection list with all of the VA measuring commands with data acquisi-
tion defined in the method.
Selection 'VA measuring command'
Tabs
￭ Data processing