Metrohm viva 1.0 (process analysis) - Manual (Page 821)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 809
Selection None | Odd | Even
Default value None
Stop bit
Number of stop bits.
Selection 1 | 2
Default value 1
Handshake
Type of the data transfer protocol.
Selection None | HW | SW
Default value None
Timeout
Maximum waiting time for receiving characters. If this time is exceeded,
receiving will be canceled.
Input range 1,000 - 9,999 ms
Default value 2,000 ms
Terminator for send
Terminator for send in hexadecimal code.
Selection \0D | \0D\0A | \0D\0A\0A | \0D\0D\0A
Default value \0D\0A
(\0D = CR, \0A = LF)
Terminator for receive
Terminator for receive in hexadecimal code.
Selection \0D | \0D\0A | \0D\0A\0A | \0D\0D\0A
Default value \0D\0A
(\0D = CR, \0A = LF)
Code page
Code page used for the data transfer.
Selection Cp437 | Cp850 | Cp852 | ASCII
Default value Cp437
Send characters one by one
on | off (Default value: off)
If this check box is activated, then each character is sent individually and
the waiting time has to elapse before the next character is sent.